Nearly every expensive roller shutter door failure in Springs started as a cheap one. A dry guide, a worn end lock, a safety edge that has quietly stopped responding. A maintenance contract exists to catch those while they are still small, and on doors that are already decades old it is the difference between a working door and a replacement.
What a roller shutter door service includes
- Curtain and slat inspection for impact damage, corrosion and edge wear.
- Guide cleaning and lubrication, which prevents most premature wear.
- Tension and balance check against the door mass.
- Barrel, bearing and shaft inspection.
- Motor, gearbox and limit check with the manual override operated.
- Safety edge and photocell test under load.
- Fixings and structural check where the guides meet the building.
Service contracts for Springs businesses
We run contracts across the engineering and manufacturing premises through Nuffield and Casseldale, the trade and workshop buildings around the industrial belt, and the retail at Springs Mall and in the CBD. Contracts are priced per door per visit with a reduced rate on multi-door sites, and every visit produces a written condition report.
Keeping old doors working
A large share of the doors we maintain in Springs are older than the people operating them. Those doors do not need replacing so much as they need attention on a schedule: bearings lubricated, guides cleared, curtain edge watched, tension checked. Maintained properly, a well-built old door will outlast a cheap new one, and we would rather keep it running than sell you a replacement you do not need yet.
How often a door should be serviced
Low-use doors once a year. Doors running more than about twenty cycles a day, twice a year. Fire shutters every six months regardless of use. Older doors and doors on dusty yards benefit from the shorter interval.
Priority response for contract sites
Contract customers go to the front of the queue on breakdowns and get labour at the contract rate rather than call-out rate. That is the practical value of a contract: not the service visit, but the afternoon the door will not close.
Body corporate and complex maintenance
Complexes through Selcourt, Selection Park, Casseldale and Pollak Park run access doors that everyone uses and nobody owns. We contract to the body corporate, report per door, and keep a record the trustees can put in front of an AGM.
Maintenance records and compliance
Every visit produces a dated report per door. Insurers and health and safety officers ask for exactly that, and having it filed already is far easier than reconstructing it after an incident.
What a service contract costs in Springs
Priced on door count, door type and visit frequency. We will quote a single service first if you would rather see the standard of work before committing.
Common questions
About roller shutter door service contracts and maintenance
It follows cycles, not the calendar. A dock door opening fifty times a day wants quarterly attention; a workshop door opening twice a day is fine annually. We set the interval from your actual usage rather than selling everyone the same schedule.
On a high-cycle door, yes — usually by a distance. Almost every emergency callout we attend was preventable: springs fatigue predictably, limits drift gradually, guides fill with debris slowly. On a door opened twice a day the maths is closer, and we will say so rather than sell you a contract you do not need.
Yes. Contract sites go to the front of the queue on emergency calls, which on a trading day is usually the part that matters most.
Every visit produces a written report covering what was checked, what was adjusted and what is likely to need attention next. That is the document your insurer, fire consultant or health and safety officer will ask for.
Related
Also worth a look
Roller Shutter Door Installation
Measured to the structure, not the catalogue
Low lintels in Geduld, out-of-square openings in the old industrial buildings. We measure what is actually there so the door fits the first time.
Read more about Roller Shutter Door InstallationRoller Shutter Door Spares and Replacement Parts
Springs, motors, slats, tracks
Springs, motors, slats, guide rails and remotes for roller shutter doors of all common makes. Where a door is worth saving, we repair rather…
Read more about Roller Shutter Door Spares and Replacement PartsEmergency Roller Shutter Door Repairs
Standby cover across the far East Rand
A shutter stuck open on a Nuffield workshop or a CBD shopfront gets a standby team out with slats, springs and motor stock already…
Read more about Emergency Roller Shutter Door Repairs