Roller Shutter Door Spares and Replacement Parts in Springs

Roller shutter door spares in Springs are almost always needed at short notice, and the difference between a door back in service today and a door out for a fortnight is whether the part is held locally. We stock the parts our own doors use and the common sizes for the makes that keep turning up on East Rand sites.

Roller shutter door spares we supply in Springs

• Slats and curtain sections in the common galvanised and aluminium profiles.
• Guides and guide inserts, including deeper sections for impact-prone bays.
• Springs, shafts and barrel components matched to span and door mass.
• Tube and side motors, gearboxes and manual overrides.
• Bottom rails, locks and end locks.
• Safety edges, photocells, control panels and remotes.

Parts for older and obsolete doors

This is where Springs differs from most towns we serve. The industrial stock through Nuffield and Casseldale runs a lot of doors that were installed before the current profiles existed, and the original manufacturers are long gone. We fabricate slats, adapt guides and machine barrel components to bring those doors back into service, and we say plainly when an adaptation is a stopgap rather than a proper fix.

Garage door spares

We carry torsion and extension springs, cables, drums, rollers, hinges, brackets and operator parts for sectional and roll-up garage doors, which covers most of the residential work through Geduld, Bakerton, Strubenvale, Dersley, Selcourt and Selection Park.

Identifying the right part

Most wrong parts get ordered from a description. Send photographs of the fault, the barrel end, the guide section and any plate on the motor, plus the opening width. From that we can usually identify the part without a site visit, and we would rather ask for one more photo than send you the wrong item.

Supply only or supply and fit

We sell parts across the counter to maintenance teams and contractors who do their own work, and we fit them where you would rather the job was warranted end to end. Tension component work in particular is worth having done by someone with the correct tools, because a wound torsion assembly is a real hazard.

Consumables worth holding on site

Sites that run doors hard tend to keep a small stock of end locks, bottom-rail seals, photocell pairs and a spare remote. It is very little money against the cost of a door standing.

What spares cost

Parts are priced on the item, not on how urgently you need them. We quote before supplying and tell you when a repair kit is better value than the individual part.

Ordering roller shutter door spares in Springs

Send photos and the opening size. We confirm the part, the price and whether it is in stock, on order or has to be made before you commit.